The PH-1200 is a receiver hitch system used to carry, load, and move
heavy items with or without the aid of other vehicles or devices. This system
was designed to accept any standard 2” receiver hitch attachment and can be
used for an unlimited number of tasks.
The crane attachment has the potential to, lift upwards of 500-lbs, be
pulled around by hand, and lift items onto trucks, docks, trailers, etc…
The PH-80 wire spooler attachment can be used to unspool a wide range of
wire sizes anywhere from 2' tall to 5' tall. it can also be rotated to a horizontal
position which then allows it to unspool two roles of barbwire at a time.
The tow bar attachment allows the PH-1200 to be turned into a small flat
bed trailer with a weight carrying capacity of up to 1200-lbs. Items can be
towed by hand or by a small mower, garden tractor, or a vehicle which
otherwise would be much too small to handle the load.
A standard trailer hitch is a common use for the PH-1200. When using this
ball hitch it is possible to connect a trailer and have the entire tongue weight
rest on the PH-1200. The advantage of this is that it becomes possible to move
large and heavy trailers by hand or with the aid of a small mower, garden
tractor, or four wheeler, which otherwise could never support the entire
tongue weight of the trailer.
One of the original purposes of the PULLANDHAUL system was to
launch deep keeled sailboats. Because it is completely submersible this
can be achieved by pinning a large D-ring and tow strap in place of the
handle, then attaching the other end of the strap to a truck, and gently
lowering the boat deep enough into the water to launch.
The PH-1200 with its six stacked receiver hitches allows for several height
adjustments with any of the attachments.
The PH-1200 is small enough to be taken indoors and used for difficult
jobs. This system has been proven to minimize injuries from lifting and
carrying heavy objects with its wide range of useful attachments.
Here at Pull and Haul we realize that we have only scratched the surface
with the attachments that we currently provide. Therefore, we welcome the
opportunity to build any attachment that you can not find to fit your needs.
The PH-1200 IS NOT a high speed device!!! It was designed for speeds
NO GREATER than 5mph. It is strictly for the use of moving heavy loads at
low speeds!!!